Powering Up; Selecting An Input; Using The On-Screen Menu System; Menu Selection Buttons - Extron electronics IN1804 Series User Manual

Powering Up

When power is applied to the switcher, the Input 1 LED blinks prior to the full boot-up of the
product. When boot-up is complete or nearing completion, each of the input LEDs lights,
one at a time, in ascending order (1 through 4).
Next, each of the signal status LEDs lights in the same manner. When boot-up is complete
and after the LED lighting sequences occur, normal operation begins.

Selecting an Input

Press any of the four input buttons on the front panel to select an input. The green LED for
the selected input lights.
You can also select inputs via the Contact/Tally ports. See
Connectors

Using the On-Screen Menu System

The OSD menus are used primarily for the initial setup of the device. The on-screen menu
presents configuration options on a local monitor and can be adjusted with front panel
controls.
NOTE: The on-screen menu has a default timeout of 60 seconds.

Menu Selection Buttons

1 1 1
2 2 2
Figure 17.
•
•
•
on page 19 for more information.
3 3 3
5 5 5 6 6 6
MENU
4 4 4
ENTER
HOLD FOR 720p/1080p
Menu Selection Buttons
Menu button — Press the Menu button (see figure 17,
on-screen menu, deselect a submenu, or cancel a pending change.
Enter button — Press the Enter button (
submenus, or submenu items, or to accept pending changes.
Navigation buttons — Press these buttons to navigate through the menu system:
>
Press the (Up) ( ) or the
• 3
submenu items.
Press the „ (Right) arrow button (
•
submenu items.
Press the ƒ (Left) (
6
•
submenu items. You can also use the navigation buttons to adjust settings
according to specific setting directions.
Wiring the Contact/Tally
) to access the on-screen menu, select
2
<
(Down) ( ) arrow button to navigate submenus or
4
) to access currently selected submenus or
5
) arrow button to exit currently selected submenus or
IN1804 Seamless Scaling Switchers • Operation
) to activate or exit the
1
22