Table of Contents
Advertisement
3. When finished editing, click Save to confirm your changes or Cancel to close the window without making
changes. You can also close the window by clicking the X in the upper-right corner of the screen.
NOTE: If DHCP is being enabled, the web page attempts to redirect and connect to the unit via the unit name
(TCP/IP hostname). If a static IP address is being set, the web page attempts to connect to the new IP
address.
RS-232 Panel
The view-only RS-232 panel (see
CrossPoint 82 serial port. The defaults are:
•
Baud rate — 9600
•
Parity Bit — N (none)
•
Data bits — 8
•
Stop bits — 1
figure
48,
on page 91) displays the RS-232 protocol for the DTP2
8
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Internal Web Pages
98
Advertisement
Table of Contents
