Table of Contents
Advertisement
SIS Configuration and Control
The DTP2 CrossPoint 82 switchers can be configured and controlled via SIS commands when connected to a
host computer or other device (such as a control system). Attach the host device to the rear panel RS-232
connector or LAN connector, or to the front panel USB port. Commands can be entered using a Telnet application
such as the Extron DataViewer, available at
The default protocol for the RS-232 connection is 9600 baud, 8 data bits, 1 stop bit, no parity, and no flow control.
This section describes SIS communication and control. Topics in this section include:
•
Host and Switcher Communication
•
SIS Overview
•
Command and Response Tables for SIS Commands
Host and Switcher Communication
SIS commands consist of one or more characters per field. No special characters are required to begin or end a
command sequence. When the switcher determines that a command is valid, it executes the command and
sends a response to the host device. All responses from the switcher to the host end with a carriage return and a
line feed
(CR/LF = ] ), indicating the end of the response character string (one or more characters).
Copyright Messages
The copyright message is displayed upon connecting to a switcher via USB, Telnet, SIS via SSH or after a power
cycle via RS-232, and depends on the switcher model.
] (c) Copyright YYYY, Extron Electronics, DTP2 CrossPoint 82 <model>, Vn.nn, 60-1812-0n ]
Ddd, DDD MMM YYYY HH:MM:SS ] (day, date, and time as in Mon, 09 Dec 2019 11:27:33)
•
YYYY is the year.
•
<model>, if applicable, is IPCP SA or IPCP MA 70
•
60-1812- nn is the model part number:
•
DTP2 CrossPoint 82 base model — 60-1812-01
•
DTP2 CrossPoint 82 IPCP SA — 60-1812-02
•
DTP2 CrossPoint 82 IPCP MA 70 — 60-1812-03
•
V n.nn is the firmware version number.
Password Messages
If the DTP2 CrossPoint 82 is protected by a password, the following password message prompts you for the
password to access the switcher features.
] Password ]
The prompt requires a password, followed by a carriage return. The prompt is repeated if the correct password is
not entered.
•
For initial setup: On the rear panel of the DTP2 CrossPoint 82, a label is attached containing the following:
The factory-configured passwords for all accounts on this device have been set to the device serial
number. Passwords are case-sensitive.
www.extron.com
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
(see the DataViewer Help file for more details).
47
Advertisement
Table of Contents
