Table of Contents
Advertisement
Exit
This option disconnects PCS from connected devices and closes the application.
1. From the Software menu, select Exit. If device tabs are open, the Exit dialog box opens.
Figure 45. Exit Dialog Box
2. If necessary, click the Close Session(s) and Exit button (see figure 45,
connected devices, close all offline device tabs, and close the software. Click the Cancel button (
the software open.
Device Menu
The Device drop-down menu contains options pertaining to device connection, configuration, and information.
For details about all these options, see the DTP2 CrossPoint 82 PCS Help File.
Figure 46.
Device Menu
•
Disconnect — Disconnects the PCS program from the connected device and closes the device tab.
NOTE: If a device is already disconnected, the Disconnect option is disabled until the device is
connected.
•
Settings — Opens a submenu containing the following options:
•
Hardware Settings — Displays the Hardware Settings dialog box containing device information and
side tabs that enable you to change the device name, internal clock, and password of the connected
device.
NOTE: The initial factory configured passwords for all accounts on this device have been set to the
device serial number. Passwords are case sensitive. In the event of an absolute system reset, the
passwords are reset to no password.
It also contains an Edit Communication Settings button, which provides an alternative method of
accessing the Communication Settings dialog box.
•
Communication Settings — Opens the Communication Settings dialog box on which you can change
IP settings of the connected device.
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Configuration Software
) to disconnect the software from
1
2
) to leave
88
Advertisement
Table of Contents
