Powering On; Self-Test - Extron electronics DXP HD 4K PLUS Series User Manual

J

Powering On

Apply power as follows:
•
•

Self-test

When power is applied to the DXP, the switcher performs a self-test as follows:
•
•
NOTE: The factory configured passwords for all accounts on this device have been
set to the device serial number.
Performing a unit factory reset (entering an
a mode 5 reset via the rear panel Reset button) removes the serial number
passwords, leaving the unit with no password.
Reset button — (DXP 42 only) This recessed button initiates four levels (modes) of
reset on the DXP switcher (see figure 9,
levels, use a pointed object such as a small Philips screwdriver or a stylus to press
and hold the button while the switcher is running or while it is being powered up (see
Resetting on page 32).
DXP 44, 84, and 88 — Connect the provided IEC power cord to the rear panel IEC
connector (figure 3, , on page 7) and to an AC source.
I
DXP 42 — Connect the provided 12 V, 1.5 A power supply to the rear panel 2-pole
captive screw connector (see figure 4,
DXP 44, 84, and 88 — The front panel input, output, and I/O button LEDs blink red,
then green, while the control button LEDs blink green. All LEDs turn off except the I/O
LEDs, which light steadily red for several seconds. The I/O LEDs remain lit red while a
self-test is performed, during which the green Input Signal and HDCP LEDs also light in
order in a clockwise circling pattern. If error-free, the self-test ends with only one of the
I/O LEDs lit, reflecting the previous selection of audio or video. If an error occurs during
the self-test, the DXP locks up and does not operate. If this occurs, call the
S3 Sales & Technical Support Hotline
information in your area).
The current configuration, EDID information, and all presets are saved in memory. When
power is applied, the most recent configuration is retrieved. The previous presets remain
intact. The switcher powers up in full power mode (neither power save mode enabled).
DXP 42 — All the front panel button LEDs blink. After the power up sequence is
completed, the button LEDs turn off. The Signal and HDCP LEDs light according to the
current state of each input.
E }
ZQQQ SIS command or
, on page 16). To initiate the different reset
J
, on page 8).
I
(see the last page of this guide for contact
DXP HD 4K PLUS Series • Operation
Extron
19