Table of Contents
Advertisement
Input Submenu
Figure 22.
Input Submenu
The Input submenu adjusts the active input.
•
INn: Input Mode — Displays the signal type of the selected input.
•
For input 1 it shows DisplayPort if a DisplayPort source is connected, No Signal if not (view-only).
•
For inputs 2 through 6 it displays HDMI or DVI as appropriate if a source is connected, No Signal if not
(view-only).
•
For inputs 7 and 8, use the
is connected, both options also display (No Signal).
•
INn: Film Detect — Film mode detection helps maximize image detail and sharpness for video sources
originating from film. Press Enter to select the item, then press the
(default) and Off.
If On is selected, the DTP2 CrossPoint 82 detects and applies reverse pull-down for:
•
3:2 pull-down for 480i and 1080i @ 59.94 Hz
•
2:2 and 24:1 pull-down for 576i and 1080i @ 50 Hz
•
Active Video — This view-only field shows the width in pixels (the H value) and the height in lines (the V
value) of the applied input signal.
•
HDCP Authorized — This feature determines if a digital input reports as an HDCP authorized sink to a
source. Select this item to enable or disable HDCP communication by selecting whether the
DTP2 CrossPoint 82 input reports to the source as an authorized HDCP sink. Press Enter to select this item,
then press the
For source devices that require encryption, enable HDCP Authorized. If HDCP Authorized is disabled for
sources that require encryption (for example, a Blu-ray player), the output is muted or a warning message is
displayed. Some source devices may encrypt their output even if the source material does not require HDCP
encryption, preventing content from being displayed on a non-HDCP compliant display. Disable HDCP
Authorized to allow the output of the switcher to remain unencrypted.
NOTE: HDCP Authorized is permanently enabled on DisplayPort Input 1.
and
or
button to toggle between On (default) and Off.
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
buttons to select between DTP and XTP. If no DTP or XTP source
and
buttons to toggle between On
29
Advertisement
Table of Contents
