Wedge Quiet Interval; Intercode Delay - Datalogic QuickScan QM24 Series Product Reference Manual

Keyboard Settings

Wedge Quiet Interval

Specifies amount of time to look for keyboard activity before scanner breaks keyboard connec-
tion in order to transmit data to host. The selectable range for this setting is 00 to 990 millisec-
onds (00-0x63 by 01) in increments of ten milliseconds. See
detailed information and examples for setting this feature.
$CKBQI
Set Wedge Quiet Interval
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable
range for this feature is from 0 to 99 seconds.
See page 242 in "References" for detailed information and examples for setting this feature.
$CKBID
Set Intercode Delay
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
0A = Quiet Interval is 100 milliseconds
DEFAULT
DEFAULT
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
00 = No Wedge Intercode Delay
Enter/Exit Programming Mode
page 240 in "References" for
representing your
CANCEL
representing your
CANCEL
45