Testing Communications With Ezsetup - Campbell CR300 Series Product Manual

14. Testing communications
with EZSetup
1. Advance to, or select, the Communication Test step in EZ Setup. See
communications (p. 21) for more information.
2. Ensure the data logger is physically connected to the computer, select Yes to test
communications, then click Next to initiate the test. To troubleshoot an unsuccessful test,
see Tips and troubleshooting (p. 168).
3. With a successful connection, the Connection Time with the data logger is displayed in the
lower-left corner of the wizard. Click Next.
4. The Datalogger Clock window displays the time for both the data logger and the computer
(server).
The Adjusted Server Date/Time displays the current reading of the clock for the
l
computer running your data logger support software. If the Datalogger Date/Time
and Adjusted Server Date/Time do not match, click Set Datalogger Clock to set the
data logger clock to the computer clock.
Optionally, specify a positive or negative Time Zone Offset to apply when setting the
l
data logger clock. This offset allows you to set the clock for a data logger that is in a
different time zone than the computer (or to accommodate for changes in daylight
saving time).
5. Click Next.
USB or RS-232
14. Testing communications with EZSetup 69