Configure The Rf407-Series Base Radio - Campbell CR300 Series Product Manual
Compact datalogger
Hide thumbs
Also See for CR300 Series:
- Product manual (258 pages) ,
- Operator's manual (86 pages) ,
- Getting started manual (27 pages)
Table of Contents
Advertisement
NOTE:
Most Campbell Scientific devices come from the factory with a default PakBus address of 1.
For this reason, it is best not to assign PakBus address 1 to any device in the network. Then, if
a new device with default settings is added to the system, it will not create a conflict.
13.3.1 Configure the RF407-series base radio
Configure the base radio. This is the RF407-series radio that is connected to the computer (see
previous image for reference).
1. Ensure that an antenna is connected to the RF407-series radio.
2. If connecting via USB for the first time, you must first install USB drivers using Device
Configuration Utility (select your radio, then on the main page, click Install USB Driver).
13. Radio communications option 60
Advertisement
Table of Contents
Troubleshooting
