Usb Communications - Campbell CR300 Series Getting Started Manual

2. USB communications

Setting up a USB connection is a good way to begin communicating with your data logger.
Because this connection does not require configuration (like an IP address), you need only set up
the communications between your computer and the data logger. Use the following instructions
or watch the Quickstart videos at
TIP:
You will physically connect your data logger to your computer in step 6.
Follow these steps to get started. These settings can be revisited using the data logger support
software Edit Datalogger Setup option
1. Using data logger support software, launch the EZSetup Wizard.
NOTE:
New software installations automatically open the EZSetup Wizard the first time they
run.
LoggerNet users, click Setup
l
(Simplified) view, then click Add Datalogger
PC400 users, click Add Datalogger
l
2. Click Next.
3. Select CR300 Series from the list. In the Datalogger Name field, type a meaningful name for
your data logger (for example, a site identifier or project name), and click Next.
4. Select the Direct Connect connection type and click Next.
5. If this is the first time connecting this computer to a CR300 series via USB, click Install
USB Driver, select your data logger, click Install, and follow the prompts to install the
USB driver.
6. Plug the data logger into your computer using a USB cable. The USB connection supplies
5 V power as well as a communications link, which is adequate for setup, but a 12 V power
source is necessary to power cellular functions of CR300-CELL series models. A 12 V battery
will be needed for field deployment as the USB connection cannot power most sensors.
https://www.campbellsci.com.au/videos
.
, select the View menu and ensure you are in the EZ
.
.
.
2. USB communications 2