Dns; Ethernetinfo; Ethernetpower; Filesmanager - Campbell CR300 Series Product Manual

23.3.6 DNS

This setting specifies the addresses of up to two domain name servers that the data logger can
use to resolve domain names to IP addresses. Note that if DHCP is used to resolve IP information,
the addresses obtained via DHCP will be appended to this list.
NOTE:
When setting a static IP address, first manually set a DNS Server Address in Settings Editor >
Advanced.
String data type
l

23.3.7 EthernetInfo

Reports the IP address, network mask, and default gateway for each of the data logger's active
network interfaces. If DHCP is used for the interface, this setting will report the value that was
configured by the DHCP server.
String data type
l
Read only
l

23.3.8 EthernetPower

This setting specifies how the data logger controls power to its Ethernet interface. This setting
provides a means of reducing the data logger power consumption while Ethernet is not
connected. Always on, 1 Minute, or Disable.

23.3.9 FilesManager

This setting controls how the data logger will handle incoming files with specific extensions from
various sources. There can be up to four specifications. Each specification has three required
fields: PakBus Address, File Name, and Count.
String data type
l

23.3.10 FTPEnabled

Set to 1 if to enable FTP service. Default is 0.
23. Information tables and settings (advanced) 213