23.2.10 LastSlowScan
Reports the time of the of the last Slow Sequence scan.
23.2.11 LithiumBattery
Voltage of the internal lithium battery. Updated at CR300 series power up. Status of the battery is
indicated by either OK, ON POWER UP or FAIL, ON POWER UP. For battery information, see
Internal
battery (p. 162).
String data type
l
23.2.12 MaxProcTime
Maximum time (μs) required to run through processing for the current scan. Value is reset when
the scan exits. Enter 0 to reset. Updated at the conclusion of scan processing, prior to waiting for
the next scan.
23.2.13 MaxSlowProcTime
Maximum time (μs) required to run through processing for the current Slow Sequence scan.
Value is reset when the scan exits. Enter 0 to reset. Updated at the conclusion of scan processing,
prior to waiting for the next scan.
23.2.14 MeasureTime
Reports the time (μs) needed to make measurements in the current scan. Calculated at compile
time. Includes integration and settling time. Assumes all measurement instructions will run each
scan. Updated when a main scan begins.
23.2.15 MemoryFree
Unallocated final-data memory on the CPU (bytes). All free memory may not be available for data
tables. As memory is allocated and freed, holes of unallocated memory, which are unusable for
final-data memory, may be created. Updated after compile completes.
23.2.16 MemorySize
Total final-data memory size (bytes) in the CR300 series. Updated at startup.
23. Information tables and settings (advanced) 206