Table of Contents
Advertisement
ADJUSTMENT AFTER I NSTALLATI 0 N
Trim Tab Adjustment
Single Motor
After the engine break-in, run the boat at full speed and
check to see if the boat pulls to the left or right. Adjust the
trim tab as required to ensure good and straight running
characteristics.
If the boat pulls to the left:
Loosen the trim tab lock bolt, and move the trim tab trailing
edge to the left.
//
Pulling to the right
If the boat pulls to the right:
Loosen the trim tab lock bolt, and move the trim tab trailing
edge to the right.
Dual Motors
1.
Remove the trim tab lock bolt and trim tab from the
standard rotation outboard motor.
2.
TRIM TAB
(Single motor
use only)
TRIM TAB LOCK BOLT
(10 x 32 mm HEX BOLT)
Replace the t r i m tab t o the gear case cover and
tighten it with a trim tab lock bolt (10
x 32
m m hex
bolt) as specified torque.
TORQUE : 34 N.m (3.5 kgf-m, 25 IbfW
43
Hide quick links:
Advertisement
Table of Contents
