Table of Contents
Advertisement
CAUTION: Failure to completely snap the heatsink blank into place could result in damage to the equipment.
2. Install the access panel.
3. Install the server blade.
4. Power up the server blade.
More information
Power up the server blade
Replacing the access panel
Install the server blade
Removing and replacing the server blade release lever assembly
Removing the server blade release lever assembly
Prerequisites
A T-15 Torx screwdriver is required to perform this procedure.
Procedure
1.
Power down the server blade.
2.
Remove the server blade.
3.
Place the server blade on a flat, level work surface.
4.
Remove the access panel.
5.
Remove all drives and drive blanks (Removing and replacing the drive bay options).
6.
Remove the mezzanine assembly (Removing the mezzanine assembly).
7.
Do one of the following:
Remove the storage controller or the NVMe pass-through board (Removing a storage controller or NVMe
•
pass-through board).
•
Remove the direct connect SATA cable (Removing and replacing the direct connect SATA cable).
8.
If installed, remove the internal USB drive.
Removal and replacement procedures
75
Advertisement
Table of Contents
