Table of Contents
Advertisement
Replacing the mezzanine card options
Prerequisites
A T-15 Torx screwdriver is required to perform this procedure.
Procedure
1. Align the mezzanine card using the appropriate guide pins on the mezzanine assembly.
For more information, see Mezzanine connector guide pin locations.
2. Install the mezzanine card in the mezzanine assembly, and then tighten the mezzanine card screws to secure the card
to the mezzanine assembly.
3. Align the mezzanine assembly with the guide pins on the system board, and then install the mezzanine assembly on
the system board.
4. Press down firmly on the mezzanine assembly handles, and then close the mezzanine assembly latch.
Removal and replacement procedures
61
Advertisement
Table of Contents
