To locate the internal USB connector, see System board components.
IMPORTANT: When removing a DIMM baffle, do not remove the following options when installed on the
DIMM baffle:
•
M.2 enablement option (left DIMM baffle)
•
HPE Smart Storage Battery (right DIMM baffle)
IMPORTANT: When removing the right DIMM baffle, use the blue pull tab to disconnect the HPE Smart
Storage Battery cable from the system board.
9.
Remove both DIMM baffles (Removing the DIMM baffles).
10. Remove the front panel/drive cage assembly (Removing and replacing the front panel/drive cage assembly).
11. While holding the system board in place, turn the base pan on its side and remove the two system board screws from
the bottom of the base pan.
12. Place the server blade on a flat, level work surface.
13. Slide the system board approximately 1.27 cm (0.50 inches) towards the rear of the server and lift the system board
from the base pan.
Removal and replacement procedures
76