Removing And Replacing An Sff Drive; Removing And Replacing An Nvme Drive - HPE ProLiant BL460c Gen10 Maintenance And Service Manual

CAUTION: To prevent improper cooling and thermal damage, do not operate the server blade unless all device
bays are populated with either a component or a blank.
To replace the blank, slide the blank into the bay until it locks into place.

Removing and replacing an SFF drive

Procedure
1. Determine the status of the drive from the drive LED definitions.
2. Back up all data on the drive.
3. Remove the drive.
To replace the drive, slide the drive into the bay until it is fully seated, and then close the latch handle to lock the drive in
the bay.
More information
Hot-plug drive LED definitions

Removing and replacing an NVMe drive

Procedure
1. Observe the LED status of the drive and determine if it can be removed.
2. Remove the drive:
a. Press the power button.
The Do Not Remove button illuminates and flashes. Wait until the flashing stops and the Do Not Remove button is
no longer illuminated.
b. When the Do Not Remove button is no longer illuminated, press the Do Not Remove button and then remove the
drive.
Removal and replacement procedures
44