Relocate The Pem Nut And Rubber Stopper - HPE ProLiant BL460c Gen10 Maintenance And Service Manual

Relocate the PEM nut and rubber stopper

This procedure is required if the PEM nut and rubber stoppers must be relocated to support the length of the M.2 SSDs
being installed.
Prerequisites
To remove the M.2 SSDs from the M.2 riser, you need a No. 1 Phillips screwdriver.
Procedure
1. Power down the server blade.
2. Remove the server blade.
3.
Place the server blade on a flat, level work surface.
4. Remove the access panel (Removing the access panel).
5. Remove the left DIMM baffle (Removing the DIMM baffles).
6. Remove the M.2 interposer board and the M.2 riser board.
7. If installed, remove an M.2 SSD from the M.2 riser board (Removing and replacing an M.2 SSD).
8.
Remove the rubber stoppers from the M.2 riser.
Removal and replacement procedures
36