Honda Shadow TA200 2001 Manual page 165

BEARING REPLACEMENT
BEARING INSPECTION
Turn the i n ner race of each bearing with your finger.
The bearing should turn smoothly and quietly.
Also check that the bearing outer race has not been spinning
in the crankcase.
Replace the crankshaft i f the races do not turn smoothly and
quietly, or i t they have been spinning i n the crankcase.
CRANKSHAFT/TRANSMISSION
CRANKSHAFT BEARING
Remove the bearings from crankcase halves.
PLATE
INSTALLER
Clean the crankcase mating surface throughly, be careful not
to damage the mating surface.
Apply engine oil to the new crankshaft bearing and place i t
on the crankcase.
Set the i n staller (special tool) i n to the i n ner race of the bear-
ing.
Place the plate (special tool) over the i n staller (special tool).
Align the center of the i n staller (special tool) when setting on
to the bearing.
NOTE:
Installer (special tool) has an i d entification mark.
/
,
BEARING PILOT
I D ENTIFICATION MARK
\,
\
CRANKCASE
TOOLS:
Righi side:
Installer, depth 27.4
Pilol 35 mm
Left side:
Installer, depth 27.12
Pilot 28 mm
070MF- KPKT100
070MF - KPKT200
I N STALLER
Press the center of the plate (special tool) using a hydraulic
press until the plate (special tool) touch with the crankcase
surface.
CAUTION:
Press the plate (special tool) slowly.
• Do not damage the crankcase and bearing.
After the i n stallation, check for the distance between the crank-
shaft bearing surface (Connecting rod side) and upper sur-
face of the crankcase.
Right side: 27.40- 27.45 mm (1.079 -1.081 in)
Left side: 27.12- 27.17 mm (1.068-1.070 in)
HYDRAULIC PRESS
·; - . . . _ ,t__,
INSTALLER
11-7