Honda Shadow TA200 2001 Manual page 240

HYDRAULIC BRAKE
Apply silicone grease to the boot groove i n the push rod.
Install the boot into the master cylinder and the groove i n the
push rod.
If the push rod joint i s reinstalled, adjust the push rod l e ngth
so that the distance from the center of the master cylinder
lower mounting hole to the center of the joint pin hole is 84 -
86 mm (3.3 - 3.4 in).
After adjustment, tighten the l o wer joint nut.
TORQUE: 18 N-m (1 .8 kgf.m, 13 lbf.ft)
INSTALLATION
Connect the reservoir hose to the hose joint.
Coat the new 0-ring with clean brake fluid and install i t onto
the reservoir hose joint.
BOOT
I
84 - 86 mm (3.3 - 3.4 in)
JOINT NUT
SCREW
Install the reservoir hose joint to the rear master cylinder.
Install and tighten the screw to the specified torque.
TORQUE: 2 N-m (0.2 kgf-m, 1 .4 lbf·fl)
Install the rear mastar cylinder, collars and tighten the bolts
securely.
14-24
RESERVOIR HOSE
RESERVOIY1 R
HOSE JOINT
'
'
!1111! ,
I
lltiiijjjillll
f
0-RING /
MASTER
CYLINDER
COLLARS