Honda Shadow TA200 2001 Manual page 241

Install the l o wer joint and new cotter pin.
Connect the brake hose to the rear master cylinder with new
sealing washers.
NOTE:
Be careful not to twist the brake hose.
Install and tighten the brake oil bolt to the specified torque.
TORQUE: 34 N,m (3.5 kgf,m, 25 tbf,ft)
NOTE:
While tightening brake oil bolt, align the brake hose end with
the stopper.
Connect the reservoir hose to the master cylinder reservoir
tank.
Install the master cylinder reservoir tank to the frame.
Install and tighten the bolt securely.
Refill the brake fluid and bleed the rear hydraulic system (page
14-5).
Install the right side cover (page 2-2).
REAR BRAKE CALIPER
CAUTION:
A void spilling brake fluid
on
painted, plastic orrubber parts.
Place a rag or shop towel over these parts whenever the
system is serviced.
When removing the oil hose bolt, cover the end of the
hose to prevent contamination.
REMOVAL
Drain the brake fluid (page 14-4).
Remove the pad pin plug and l o osen the pad pin (page 14-9).
Remove the brake oil bolt and sealing washers.
Disconnect the brake hose from the rear brake caliper.
Remove the rear caliper bracket bolts and rear caliper.
Remove the brake pad (page 14-9).
HYDRAULIC BRAKE
SEALING WAS
OIL BOLT
BOLTS
14-25