4.2 Connecting The Simple Logger ® Ii To A Computer; Turning The Unit On - AEMC SIMPLE LOGGER II User Manual

Trms voltage

Hide thumbs Also See for SIMPLE LOGGER II:

Table of Contents

4.2

Connecting the Simple Logger

INSTALL THE DATAVIEW

LOGGER

Figure 4-1 shows a typical hook-up. The Simple Logger

cally isolated USB communication port.

Refer to the computer manual to locate the USB port on your computer.

The logger can be connected to the computer during a recording session,

however, additional battery drainage will occur to support the active USB

connection.

4.3

Turn the instrument ON by performing one of the following:

• Press and hold the PRESS button for approximately 2 seconds.

Release the button after all five LEDs light up in unison. The unit is

now in the STANDBY mode (Green LED single-blinks).

NOTE: if the LEDs light in sequence the instrument is already ON. In

this case continue to hold the PRESS button until all LEDs are OFF.

• Connect the instrument to a USB port on your computer and establish

communication with the instrument using DataView

remain ON while a communication link with DataView

vided sufficient battery power is available during the communication

session).

II TO THE COMPUTER.

SOFTWARE BEFORE CONNECTING THE SIMPLE

Figure 4-1

II to a Computer

II utilizes an opti-

. The logger will

is active (pro-

Simple Logger

II Model L261

Table of Contents

L261