Toshiba GR200 Series Instruction Manual page 1569

PDIS class
Attribute Name Attr. Type Explanation
LNName
Data
Common Logical Node Information
OpCntRs INC
Status Information
Str ACD_ABC Start
Op ACT_ABC Operate
Settings
PoRch ASG
PhStr ASG
GndStr ASG
DirMod ING
PctRch ASG
Ofs ASG
PctOfs ASG
RisLod ASG
AngLod ASG
TmDlMod SPG
OpDlTmms ING
PhDlMod SPG
PhDlTmms ING
GndDlMod SPG
GndDlTmms ING
X1 ASG
LinAng ASG
RisGndRch ASG
RisPhRch ASG
K0Fact ASG
K0FactAng ASG
RsDlTmms ING
PHAR class
Attribute Name Attr. Type Explanation
LNName
Data
Common Logical Node Information
OpCntRs INC
Status Information
Str ACD_ABC Start
Settings
HarRst ING
PhStr ASG
PhStop ASG
OpDlTmms ING
RsDlTmms ING
Shall be inherited from Logical-Node Class (see IEC 61850-7-2)
LN shall inherit all Mandatory Data from Common Logical Node Class
Resettable operation counter
Polar Reach is the diameter of the Mho diagram
Phase Start Value
Ground Start Value
Directional Mode
Percent Reach
Offset
Percent Offset
Resistive reach for load area
Angle for load area
Operate Time Delay Mode
Operate Time Delay
Operate Time Delay Multiphase Mode
Operate Time Delay for Multiphase Faults
Operate Time Delay for Single Phase Ground Mode
Operate Time Delay for single phase ground faults
Positive sequence line (reach) reactance
Line Angle
Resistive Ground Reach
Resistive Phase Reach
Residual Compensation Factor K0
Residual Compensation Factor Angle
Reset Time Delay
Shall be inherited from Logical-Node Class (see IEC 61850-7-2)
LN shall inherit all Mandatory Data from Common Logical Node Class
Resettable operation counter
Number of harmonic restrained
Start Value
Stop Value
Operate Delay Time
Reset Delay Time
- 1546 -
6F2S1914 (0.49)
(MICS Ed.1)
T M/O GRL200
M
O N
M Y
T M Y
O Y
O Y
O Y
O Y
O N
O Y
O N
O N
O N
O N
O Y
O N
O N
O N
O N
O Y
O Y
O Y
O Y
O N
O N
O N
T M/O GRL200
M
O N
M Y
O N
O Y
O N
O N
O N
GRL200 (Soft 033 & 037)