Toshiba GR200 Series Instruction Manual page 1766

Rev. and Section
Date (page)
Chap. 2.24
Chap. 2.25
Chap. 2.26
Chap. 2.29
Chap. 4.2
Chap. 4.6
Chap5.4.4(vi)
Chap.5.6.3
Chap.8.3.7
Chap. 8.4
Chap. 13.3
Chap. 13.8
Appendix 6
Appendix 6
Appendix 7
Appendix 7
Appendix 9
Safety
precautions
Chap. 2.38
Chap. 8.4
0.36 Chap. 11.3
Feb.28,2019
Chap. 13.8
Appendix 4
Appendix 7
Chap. 2.3
Chap. 2.14
0.37
June14,2019
Chap. 3.4
Appendix 9
Change place and contents
Corrected the number of decimal places about curve
coefficient in Table 2.24-2 in UV function
Corrected the number of decimal places about curve
coefficient in Table 2.25-2 in UVS function
Removed the contents about the trip decision timing in
FRQ function
Added missing monitoring points in FS logics in Fig.
2.29-3
Added a flip-flop at detection of state change at a device
in Fig. 4.2-20, -24, -28
Corrected the location of drop-off delay timers in Fig.
4.6-10, -11
Added the notice about Latch output during power turn
on/off
Corrected F7 setting names of Table 5.6-6 in HMI
contents
Added the content about the interpolate mode setting
in Disturbance recorder
Added signals for transferring fault record information
in IEC61850
Modified the inquiry address at Toshiba Energy
Systems & Solutions Corporation
Corrected required wire thickens in Table 13.8-1
Added new BIO codes(2F ,4R, 5P, 5Q). Added missing
BIO code (74)
Revised the notice regrading DC rated voltage when
AC power source is applied
Added the notice when the IED cannot have sufficient
optical power at the communication in Technical data
Corrected the technical information about Power
supply data in Technical data
Added matrix table between VCT and relay application
Corrected warning message at Fiber optic
(Invisible laser radiation → Class 1 laser product)
Corrected the signal destination of CB-ALLPH_CLOSE
in Fig. 2.38-1 of PROT_COMM
Revised the contents of FLTM signal mapping
regarding Ed.1_Op and Ed.2 in Recording function
Revised the operation steps to selection of 61850
editions in Fig. 11.3-7 & -23; Added Ed2 contents
Revised the content about optical cable handlings and
Fig. 13.8-6
Revised and added the information about 61850 Ed.2
Added SIR data sheets for the distance relay
Corrected the description of DIFGL computation.
DIFGL does not use 3Io, but Ie
Corrected the incorrect switch position about OCSOTF-
2PBlk in SOTF-OC logic (Fig. 2.14-1)
Added the content about setting [QBLK] in Common
controls
Corrected matrix table about DILG input signal
Approved
Checked by
by
K. Oohashi K. Kobayashi
Nov. 9 Nov. 9
K. Oohashi K. Kobayashi
Nov. 9 Nov. 9
K. Oohashi K. Kobayashi
Nov. 9 Nov. 9
K. Oohashi K. Kobayashi
Oct. 25 Oct. 25
K. Oohashi T. Utsumi
Dec. 4 Dec. 4
K. Oohashi T. Utsumi
Dec. 4 Dec. 4
K. Oohashi H. Amoh
Sep. 3 Sep. 3
K. Oohashi K. Kobayashi
Oct. 25 Oct. 25
K. Oohashi K. Kobayashi
Oct. 25 Oct. 25
K. Oohashi K. Kobayashi
Nov. 22 . 22
Nov
K. Oohashi K. Kobayashi
Oct. 1 . 1
Oct
K. Oohashi M. Ueda
Oct. 24 Oct. 24
K. Oohashi M. Ueda
Dec. 11 Dec. 10
K. Oohashi K. Kobayashi
Oct. 31 Oct. 31
K. Oohashi K. Oohashi
Oct. 24 Oct. 24
K. Oohashi K. Kobayashi
Dec. 7 Dec. 7
K. Oohashi G. Suzuki
Oct. 23 Oct. 22
K. Oohashi M. Ueda
Feb. 19 Feb. 18
K. Oohashi K. Kobayashi
Jan. 11 Jan. 11
K. Oohashi M. Okai
Feb. 20 Feb. 19
K. Oohashi M. Okai
Feb. 20 Feb. 19
K. Oohashi M. Ueda
Feb. 19 Feb. 18
K. Oohashi M. Okai
Feb. 20 Feb. 19
K. Oohashi K. Kobayashi
Jan. 31 Jan. 31
K. Oohashi K. Kobayashi
June 6 June 6
H. Amoh G. Suzuki
Jun. 11 Jun. 11
H. Amoh K. Kobayashi
June 4 June 3
K. Oohashi K. Kobayashi
Prepared by
T. Kaneko
Nov. 8
T. Kaneko
Nov. 8
T. Kaneko
Nov. 8
T. Kaneko
Oct. 24
T. Kaneko
Dec. 3
T. Kaneko
Dec. 3
T. Kaneko
Sep. 1
T. Kaneko
Oct. 24
T. Kaneko
Oct. 24
T. Kaneko
Nov. 21
T. Kaneko
Oct. 1
T. Kaneko
Oct. 23
T. Kaneko
Dec. 10
T. Kaneko
Oct. 31
T. Kaneko
Oct. 23
T. Kaneko
Dec. 5
T. Kaneko
Oct. 22
T. Kaneko
Feb. 18
T. Kaneko
Jan. 11
T. Kaneko
Feb. 4
T. Kaneko
Feb. 4
T. Kaneko
Feb. 18
T. Kaneko
Feb. 4
T. Kaneko
Jan. 30
T. Kaneko
June 5
T. Kaneko
Jun. 6
T. Kaneko
June 3
T. Kaneko