Toshiba GR200 Series Instruction Manual page 1734

2-1. Type using ring terminals and 110-250 Vdc
IED case structure
DC rated voltage
Figure-11.C illustrates external connection around the power supply module (PWS). During dielectric
voltage testing, a short-wire and a short-bar attached on the PSW shall be carefully handled; follow
the below instructions (1) and (2).
(1) The short-wire between terminal screw No.35 and No.36
Remove the short-wire for undertaking the dielectric voltage test. If the short-wire is not
✓
removed, the IED will be damaged.
After the test, reconnect the short-wire to the original positons.
✓
(2) The Short-bar between terminal screw No.37 and FG
Never remove the short-bar. If the short-bar is removed, the IED will be damaged.
✓
(1)
(2)
Figure-11.C A short-wire and a short-bar, around the PWS, for Type using ring terminals and 110-250Vdc
Type using compression terminals
✓ Type using ring terminals
110-250 Vdc
✓
24-60 Vdc
[IO#*]
T*
T*
PWS
BIO
2
4
3
FAIL1
1
8
10
9
FAIL2
7
(+) 29
30
DC/DC
(-) 31
32
35
36
37
y
38
FG
- 1711 -
[IO#*]
T*
BIO
6F2S1914 (0.49)
[VCT#*]
TC*
GRL200 (Soft 033 & 037)