Bus Led Red And Green; End Position Leds - Burkert 8695 Operating Instructions Manual

Type 8695
AS-Interface installation
10.6.3

Bus LED red and green

The red and green LEDs (bus) indicate the bus status:
LED green LED red
off off
off on
on off
flashing on
off flashing
Table 10: LED bus status - AS-Interface
10.6.4

End position LEDs

The end position is displayed optically by colored LEDs.
Figure 36: Description end position LEDs and Jumpers - AS-Interface
NOTE!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the transparent cap, do not hold the actuator of the process valve but the
connection housing.
Figure 37: Open control head
NOTE!
Damage or malfunction due to penetration of dirt and humidity.
▶ To observe degree of protection IP65 / IP67, screw the transparent cap in all the way.
POWER OFF
No data traffic (expired Watch Dog at slave address does not equal 0)
OK
Slave address equals 0
Sensor supply overloaded or external reset
End position LED green
Jumper
for assignment of end position LEDs
End position LED yellow
Transparent cap
Body casing
Connection housing
Actuator
english
45