Jumper Function; Change Assignment Of The End Position Leds - Burkert 8695 Operating Instructions Manual

Factory setting:
Color
green LED on
yellow LED off
Table 11: Assignment of LEDs - AS-Interface
10.6.5

Jumper function

You can set the color assignment of the end positions with the jumpers.
You can indicate for each color whether it applies to the Top (end position top) or Bot (end position bottom).
10.6.6

Change assignment of the end position LEDs

Figure 38: Assignment of the end position LED - AS-Interface
DANGER!
Risk of electric shock.
▶ Before working on equipment or device, switch off the power supply and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations for electrical equipment.
Procedure:
NOTE!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the transparent cap, do not hold the actuator of the process valve but the
connection housing.
→
Open the control head: turning the transparent cap anti-clockwise.
46
Device status
End position bottom
End position top
End position
LED green
Jumper for
assignment of
end position LEDs
End position
LED yellow
english
Type 8695
AS-Interface installation
Jumper setting 1:
Top
Bot
In the end position top
ye ye
(Top), the yellow LED is
gn gn
lit; in the end position
Bot Top
bottom (Bot), the green
LED is lit.
Top Bot
Jumper setting 2:
ye
ye
In the end position top
gn gn
(Top), the green LED is lit;
in the end position bottom
Bot Top
(Bot), the yellow LED is lit.