Type 8695
Electrical installation 24 V DC
9.4.3
End position LED green and yellow
Factory setting:
Color
green LED on
yellow LED on
Table 5:
Assignment of end position LEDs - 24 V DC
9.4.4
Jumper function
You can set the color assignment of the end positions with the jumpers. You can indicate for each color whether it
applies to the Top (end position top) or Bot (end position bottom).
9.4.5
Change assignment of the end position LEDs
DANGER!
Risk of electric shock.
▶ Before working on equipment or device, switch off the power supply and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations for electrical equipment.
Procedure:
NOTE!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the transparent cap, do not hold the actuator of the process valve but the
connection housing.
→
Open control head: turn the transparent cap anti-clockwise.
Figure 26:
Open control head
Device status
End position bottom
End position top
Transparent cap
Body casing
Connection housing
Actuator
english
37