Burkert 8695 Operating Instructions Manual page 27

Type 8695
Installation
DANGER!
Risk of injury from high pressure in the equipment/device.
▶ Before working on equipment or device, switch off the pressure and deaerate/drain lines.
Procedure:
→
Clamp valve body in a holding device (only required if the process valve has not yet been installed).
→
Control function A: Open process valve.
Hexagon
Nipple
Series 2100 and 2101
Figure 16: Rotating the actuator module
→
Using a suitable open-end wrench, counter the wrench flat on the pipe.
→
Place suitable open-end wrench on the hexagon of the actuator.
WARNING!
Risk of injury from discharge of medium and pressure.
If the direction of rotation is wrong, the body interface may become detached.
▶ Rotate the actuator module counter-clockwise only (see "Figure 17").
→
Rotate counter-clockwise (as seen from below) to bring the actuator module into the required position.
Figure 17: Rotating with open-end wrench
Actuator module
Series 2000 and 2012
Open-end wrench
Hexagon
Nipple
english
27