Connection With Multi-Pole Cable And Ribbon Cable Terminal - Burkert 8695 Operating Instructions Manual

Type 8695
AS-Interface installation
10.4.3

Connection with multi-pole cable and ribbon cable terminal

As an alternative to the bus connection model with 4-pole circular plug, there is the control head with multi-pole cable
(M12 circular plug) and ribbon cable terminal. The wiring diagram of the circular plug corresponds to the bus con-
nection of the M12 4-pole circular plug and can easily be connected to the ribbon cable terminal (see "Figure 31").
Figure 30: Control head 8695 with multi-pole cable and ribbon cable terminal
Handling the ribbon cable terminal
The multi-pole cable features a ribbon cable terminal - with M12 plug-in connector branch circuit - for AS-Interface
cable harness. The ribbon cable terminal contacts the AS-Interface cable harness by means of penetration technology
which allows installation by "clipping in" the AS-Interface cable harness without cutting and without removing insulation.
Figure 31: Ribbon cable terminal
Screws
M12 plug-in con-
nector branch circuit
Work steps:
→
Open the ribbon cable terminal
(loosen screws and remove cover)
→
Insert cable harness conclusively
→
Close ribbon cable terminal again
→
Tighten screws
Slightly undo thread-forming screws
(approx. 3/4 turn to the left) and position them on the
existing tapped bore and screw in.
english
41