Burkert 8695 Operating Instructions Manual page 20

3. Install control head
NOTE!
Damaged printed circuit board or malfunction.
▶ Ensure that the puck is situated flat on the guide rail.
→
Align the puck and the control head until
1. the puck can be inserted into the guide rail of the control head
and
2. the connection pieces of the control head can be inserted into the pilot air ports of the actuator.
Connection
pieces
Guide rail
Figure 9: Aligning the puck and the connection pieces
20
Puck
english
Guide rail
Puck
Connection
pieces
Pilot air ports
(actuator)
Type 8695
Installation