Installation Of The Control Head Type 8695 On Process Valves Of Series 20Xx (Classic) - Burkert 8695 Operating Instructions Manual

7.3 Installation of the control head Type 8695 on
process valves of series 20xx (Classic)
Procedure:
1. Install switch spindle
Figure 11: Installation of the switch spindle (1), series 20xx
→
Unscrew the transparent cap on the actuator.
→
Using a hexagon socket key, unscrew the orange/yellow position indicator from the inside of the actuator.
Figure 12: Installation of the switch spindle (2), series 20xx
→
Press the O-ring downwards into the cover of the actuator.
→
Manually screw the switch spindle (and the plugged-on guide element) together with the plastic part onto the
spindle of the actuator, but do not tighten spindle yet.
→
Tighten the guide element with a face wrench
→
Tighten the switch spindle on the spindle of the actuator. To do this, there is a slot on the upper side
(maximum torque: 1.0 Nm).
→
Push the puck onto the switch spindle until it engages.
journal Ø: 3 mm; journal gap: 23.5 mm
22
2)
english
Transparent cap
Position indicator
Actuator
Puck
Switch spindle
Guide element
O-ring
Plastic part
(of the switch spindle)
Spindle (actuator)
into the actuator cover (maximum torque: 8.0 Nm).
2)
Type 8695
Installation