Burkert 8695 Operating Instructions Manual page 24

Figure 14: Installing the control head, series 20xx
NOTE!
Too high torque when screwing in the fastening screw does not ensure degree of protection IP65 /
IP67.
▶ The fastening screws may be tightened to a maximum torque of 1.5 Nm only.
→
Attach the control head to the actuator using the two side fastening screws. In doing so, tighten the fastening
screws hand-tight only (maximum torque: 1.5 Nm).
24
Fastening screws
maximum 1.5 Nm
english
Type 8695
Installation