Together, In The Same Cabinet; Using Optional Voice Module Or Long Range Radio - ADEMCO Via 30+ Installation Instructions Manual

Installing Control and
RF Recelver
Circult Boards
Together,
in the Same Cabinet
IMPORTANT!
Before' installing the
cabinet's contents, be
sure to remove the ap-
propriate metal cabinet
knockouts.
DO NOT ATTEMPT TO RE-
MOVE THE KNOCKOUTS AF-
TER THE CIRCUIT BOARDS
HAVE BEEN INSTALLED.
Hang two short (black) mounting clips (provided with receiver) on the raised
cabinet tabs, as shown in Detail B below.
Insert the top of the receiver board (removed from its own case as described
in its instructions) into the slots at the top of the cabinet (see Detail A). Make
sure that the board rests on the correct row of tabs.
Swing the base of the board into the mounting clips and secure it to the cabi-
net with the accompanying screws (see Detail B).
Insert the top of the control's board into the slot in the clips and position two
long (red) clips at the lower edge of the board (see Detail C).
Swing this board into place and secure it with two additional screws.
Insert grounding lugs (supplied with the receiver) through the top of the cabi-
net into the /eft-hand terminals of the antenna blocks (at the upper edge of
the receiver board) and secure them to the cabinet top with the screws pro-
vided, as shown in Detail D.
Insert the receiver's antennas through the top of the cabinet, into the blocks'
right-hand terminals, and tighten the screws.
HOLES FOR ANTENNAS
AND GROUNDING LUGS
BOARD SUPPORTING SLOTS
RECEIVER
CIRCUIT
BOARD
CIRCUIT
BOARD
DETAIL A
SIDE VIEW OF
BOARD SUPPORTING SLOTS
SHORT MOUNTING CLIPS
CONTROL
CIRCUIT
BOARD
LONG MOUNTING CLIPS
DETAIL C
SIDE VIEW OF
LONG MOUNTING CLIPS
SCREW
DETAIL D
ANTENNA AND
GROUNDING LUG
INSTALLATION
~13-