Programming - ADEMCO Via 30+ Installation Instructions Manual

DIALER
PROGRAMMING
(*40-*50)
In Fields *40, *41, *42:
Enter up to the number
of digits shown.
Do not fill unused spaces.
Enter 0-9,
#+11 for '*',
#412 for '#',
#+13 for a pause
ARMING DING
(*51)
*40
*41
*42
*43
*45
*46
PABX ACCESS CODE (See box at left)
Enter up to 4 digits if PABX code is needed to access an outside line. If
fewer than 4 digits entered, exit by pressing * (and press 41 if entering
next field). To clear entries from field, press *40*.
PRIMARY PHONE No. (See box at left)
Enter up to 12 digits. If fewer than 12 digits entered, exit by pressing *
(and press 42 if entering next field). To clear entries from field, press
41%.
Note: Back-up reporting (8 calls are made to the secondary phone
number if no kiss-off is received after 8 attempts to the primary
number) is automatic only if there is a secondary phone number.
SECONDARY PHONE No. (See box at left)
Enter up to 12 digits. If fewer than 12 digits entered, exit by pressing *
(and press 43 if entering next field). To clear entries from field, press
*42%. See Note in field above.
SUBSCRIBER ACCOUNT. No.
Enter digits 0-9, #+11=B, #4+12=C, #4+13=D, #+14=E, or #+15=F.
Enter * as the fourth digit if a 3 digit acct no. (for 3+1 dialer reporting for-
mat) is used. Enter 0 as the first digit of a 4-digit acct no. for nos. 0000-
0999. End field by pressing * (and press next field) if only 3 digits are
used. To clear entries from field, press *43«.
PHONE SYSTEM SELECT
Enter 1 digit.
If Central Station Revr is not on WATS line:
0= Pulse Dial 1 = Tone Dial
If Central Station Revr is on WATS line:
2= Pulse Dial 3 = Tone Dial
REPORT FORMAT
Determine format to be used to report to the central station. Enter 1 digit.
0 = 3+1; 4+1 ADEMCO Low Speed Std. 6 = 4+2 ADEMCO Express
1 =3+1; 44+1 Radionics Standard 7 = ADEMCO Contact ID Reporting
2 = 442 ADEMCO Low Speed Standard
8 = 3+1; 4+1 ADEMCO Low Speed Expanded
3 = 442 Radionics Standard 9 = 3+1; 4+1 Radionics Expanded
*47
*48
*49
*50
*51
(Enter * as the 4th digit of *43, if 3+1 dialer reporting is to be used.)
For explanation of these formats, see page 30.
See field *27, which may override this field's selection.
SPLIT/DUAL REPORTING
Enter 0 to disable (Backup report only). To enable, enter 1-5.
15 SECOND DIALER DELAY (BURGLARY)
Allows time for subscriber to avoid a false alarm transmission.
Enter 0 for no or 1 for yes.
PERIODIC TEST MESSAGE
Select the desired test report interval.
O=none; 1=24hours; 2=weekly; 3= monthly
Test Report Code entered in field *64 is sent.
SESCOA/RADIONICS SELECT
Enter 0 for no or 1 for yes.
~19-