Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Cabinet and Lock Installation
For Residential Fire and/or Burglary installa-
U L
tions, use the ADEMCO RES-UL cabinet.
For Commercial Burglary installations, use the
ADEMCO COM-UL cabinet.
Before
installing
remove the metal cabinet knockouts required
for wiring entry. Do not attempt to remove the
knockouts after the circuit board has been
installed.
1. Mount the control cabinet to a sturdy wall in a
clean, dry area that is not readily accessible to the
general public using fasteners or anchors (not
supplied), in the four cabinet mounting holes.
2. Remove cabinet door, then remove the lock knockout
from the door. Insert the key into the lock.
3. Position the lock in the hole, making certain that the
latch will make contact with the latch bracket when
the door is closed.
4. When correctly positioned, push the lock until it is
held securely by its snap tabs.
Mounting the PC Board Alone
(no RF Receiver)
1. Hang two mounting clips (provided) on the raised cabinet tabs (see Detail B in Figure 2-2).
2. a. Insert the top of the circuit board into the slots at the top of the cabinet. Make sure that the board
rests on the correct row (see Detail A below).
b. Swing the base of the board into the mounting clips and secure the board to the cabinet with the accompanying
screws (see Detail B).
CIRCUIT
BOARD
DETAIL A
SIDE VIEW
OF BOARD
SUPPORTING
SLOTS
Installing the Control & Peripherals
the
cabinet's
contents,
CABINET
Figure 2-2. Mounting the PC Board
Notes:
• Use an ADEMCO No. N4445 Lock.
• The cabinet can be closed and secured without a lock
by using 2 screws in the cover's edge.
CHECK
POSITION
LOCKED
UNLOCKED
CABINET DOOR
BOTTOM
Figure 2-1. Installing the Cabinet Lock
+
+
S E C T I O N
SNAP
TAB
PUSH
SNAP
TAB
STEP 1
CIRCUIT
BOARD
DETAIL B
SIDE VIEW
OF MOUNTING
CLIPS
2
PUSH
ON LOCK
UNTIL IT
IS SEATED
SECURELY
STEP 2
CABINET
cb_mount-V0
2-1
Advertisement
Table of Contents
