Figure 3. Installing The Pc Board & Rf Receiver Together In The Cabinet - ADEMCO VIA-30Pse Installation Instructions Manual

4204, 4219, or 4229/
Expansion Unit
(if installed in cabinet)
Figure 2. Installing The PC Board in the Cabinet Alone, or (if used), with
Figure 3. Installing The PC Board And RF Receiver Together In The Cabinet
1. Insert self-tapping screws (provided) in two adjacent raised cabinet tabs.
Leave the heads projecting 1/8".
2. Hang the unit on the screw heads via two of the slotted holes at the rear of
its housing, as shown in Figure 2.
3. The expansion unit's cover can be left off if the unit's DIP switch is set with
its position 1 "ON" (to the right) as shown in its instructions. The tampered
cover is necessary for installations outside of the control's cabinet.
DETAIL B
SIDE VIEW OF
LONG MOUNTING CLIPS
a 4204, 4219, or 4229 Module.
2 –2
CIRCUIT
BOARD
CABINET
DETAIL A
SIDE VIEW OF
CONTROL
BOARD SUPPORTING SLOTS
CIRCUIT
BOARD
NOT
TAMPERED
DETAIL C
4219/4229
COVER TAMPER
JUMPER
TAMPERE