Exit Alarm Displays (If Programmed); General Information; Check" And "Battery" Displays; Other Displays (Fixed Word Consoles) - ADEMCO Via 30+ Installation Instructions Manual

Exit Alarm
Displays
(lf programmed)
General Information
"Check" and
"Battery" Displays
Power Failure
Other Displays
(Fixed Word Keypads)
A display of "CANCELED ALARM" or "CA" and a zone indication
will appear if an exit or interior zone contained a fault during closing at the time
the exit delay ended (e.g., exit door left open), but the system was disarmed
during the immediately following entry delay time. The alarm sounder and
keypad sound continuously, but stop when the system is disarmed. No
message will be transmitted to the central station.
A display of "EXIT ALARM" or "EA" and a zone indication will
appear if an exit or interior zone contained a fault during closing at the time the
exit delay ended, but the system was NOT disarmed during the immediately
following entry delay time. The alarm sounder and keypad sound continuously
until the system is disarmed (or timeout occurs). An "exit alarm" message is sent
to the central station.
The "EXIT ALARM" display, etc. will also result if an alarm from an exit or
interior zone occurs within two minutes after the end of an exit delay.
In any of the above cases, a second OFF sequence (code plus OFF key) will clear
the display.
TROUBLE CONDITIONS
The word "CHECK" on the Keypad's display, accompanied by a rapid "beeping"
at the Keypad, indicates that there is a trouble condition in the system. The au-
dible warning sound can be silenced by pressing any key. Instruct users to call for
service immediately upon seeing any of the following messages.
A display of "CHECK" and one or more zone numbers indicates that
a problem exists with the displayed zone(s) and requires attention.
When the problem has been corrected, the display can be cleared by entering
the OFF sequence (code plus OFF key) twice.
If there are wireless sensors in the system, the CHECK condition may
also be caused by some change in the environment that prevents the receiver
from hearing a particular sensor.
A display of "BAT" with no zone number indicates that the system's
main standby battery is weak.
A display of "BAT" with a zone number and a once per minute
"beeping" at the keypad indicates that a low battery condition exists in the
wireless sensor displayed (zone "00" indicates a wireless keypad). If the battery
is not replaced within 30 days, a CHECK display may occur.
Note: Some wireless sensors contain a non-replaceable long-life battery
which requires replacement of the entire unit at the end of battery life
(e.g., Nos. 5802, 5802CP, 5803).
lf there is no keypad display at all, and the POWER indicator (if
present) is not lit, operating power for the system has stopped and the sys-
tem is inoperative.
lf the message "AC LOSS" or "NO AC" is displayed, and the
POWER indicator (if present) is off, the keypad is operating on battery
power only.
If the battery standby capacity is used up during a prolonged AC
power outage, the control's auxiliary power will shut down to minimize deep
discharge of the battery.
dl If this remains displayed for more than 1 minute, the system is disabled.
CC The system is in communication with the central station for change of func-
tion or status verification.
FC Acommunication faiiure has occurred.
OC The keypad is not receiving signals from the control panel and sees an
open circuit.
-35-