Delete Key Access User(S) Using The Keypad - Kaba PowerLever 455 Series Operating Instructions Manual

Step
3. Press then 30.
4. Enter Keypad User ID.
5. Enter Keypad User ID again.
6. Repeat Steps 4–5 to delete
more User IDs or go to step 7.
Caution: If you are deleting multiple Keypad User IDs, you may need to depress the outside lever to provide
additional power.
7. Press .

Delete Key Access User(s) Using the Keypad

Note: If at any time during the procedure the lock power drops below a sufficient level for operation, the lock will
continually beep and flash the red LED, prompting the user to depress the outside lever to provide additional power.
Step
1. Power lock.
2. Enter Master User or a
Manager User combination.
3. Press then 31.
4. Enter Key User ID.
5. Enter Key User ID again.
6. Repeat Steps 4–5 to delete
Key Access Users or go to
step 7.
Detailed Instructions
Before re-lock time expires, press
then the 0 key. The lock responds with two beeps/flashes of the green LED.
Enter a Keypad User ID to be deleted (or press the Enter key to exit.) The
lock responds with two beeps/flashes of the green LED if the User ID is
valid. The lock responds with two beeps/flashes of the red LED to indicate
an error.
Confirm the Keypad User's ID by re-entering it. The lock responds with four
beeps/flashes of the green LED. The lock responds with two beeps/flashes
of the red LED if the User ID was unconfirmed, if the User ID was not in use,
or if the User ID was not that of an Access User, Audit User, or Service
User.
The Keypad User is now deleted.
If additional Keypad User IDs are to be deleted, repeat steps 4–5 until all
User IDs have been deleted. If no additional User IDs are to be deleted, go
to step 7.
Press (Enter key) to exit this procedure. The lock responds with two
simultaneous beeps/flashes of the green and red LEDs and exits this
procedure.
Detailed Instructions
Power the lock by depressing the outside lever.
Enter the Master User or a Manager User combination. The lock will beep/
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
followed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the combination is not valid, the lock responds with
three beeps/flashes of the red LED.
Before re-lock time expires, press
then the 1 key. The lock responds with two beeps/flashes of the green LED.
Enter the four-digit User ID of the Key User to be deleted. The lock responds
with two beeps/flashes of the green LED if the User ID is valid. The lock
responds with two beeps/flashes of the red LED to indicate an error.
Enter the four-digit Key User ID for verification. The lock responds with four
beeps/flashes of the green LED. The lock responds with two beeps/flashes
of the red LED if the User ID was unconfirmed or if the User ID was not in
use.
The Key Access User is now deleted.
If additional Key Access Users are to be deleted, repeat steps 4-5 until all
User IDs have been deleted. If no additional Key Access Users are to be
deleted, go to step 7.
(Enter key) followed by the 3 key and
(Enter key) followed by the 3 key and
27