Table of Contents
Advertisement
Note: If at any time during the procedure the lock power drops below a sufficient level for operation, the lock will
continually beep and flash the red LED, prompting the user to depress the outside lever to provide additional power.
Step
5.
Ensure lock remains powered
and SA Key remains in reader
until complete.
Lock User Table, Holiday & Daylight Savings Time Data Upload Via Palm Organizer
To upload the data, complete the following steps:
Step
1.
Attach Palm Organizer to PC.
2.
Create user table data on PC.
3.
Connect Palm Organizer to
lock.
4.
Power lock.
5.
Enter combination.
6.
Press
then 6.
7.
Upload lock user table data.
34
Detailed Instructions
Ensure that the lock remains powered and the SA Key remains in the reader
until the lock has completed uploading the lock user table data. Upon com-
pletion of the operation, the lock responds with two simultaneous
beeps/flashes of the green and red LEDs.
The user table has now been uploaded to the lock.
Detailed Instructions
Insert the Palm Organizer into the Palm cradle attached to the PC.
Logon to the PC software and click Locks, then Add Locks to System.
Enter the lock serial number, site number and other identifying information,
and click OK. Define Holiday Settings, Access Schedules and create the
Access User list for the lock. From the "List of Locks Processed" window,
click the Store Locks on Palm Organizer button. When finished, click the
Close button on the "List of Locks Processed" window. After all locks have
been processed, perform a Hot Sync operation with the Palm.
Connect the Palm Interface Module to the lock using the lock interface
cable.
Power the lock by depressing the outside lever.
Enter the combination. The lock will beep/flash the green LED on each key-
stroke entered. If the Clear key is pressed during data entry, the lock
responds with one beep/flash of the green LED followed by the red LED, and
all digits of the combination must be re-entered. The lock responds with
three beeps/flashes of the green LED to indicate available entry. If the com-
bination is not valid, the lock responds with three beeps/flashes of the red
LED.
Before re-lock time expires, press
lock responds with one beep/flash of the green LED every second until the
Palm interface cable has been inserted into the lock communication
connector.
Turn on the Palm Organizer and tap the Connect to Lock button at the bot-
tom of the Main Menu. Tap the Add Users button on the top of the Connect
to Lock menu. After all user table data has been uploaded, tap the Discon-
nect button at the bottom of the Connect to Lock menu. Upon completion of
the Palm operations, the lock responds with two simultaneous beeps/flashes
of the green and red LEDs.
(Enter key) followed by the 6 key. The
Advertisement
Table of Contents
