Table of Contents
Advertisement
PROCEDURE 5 - DELETE MANAGER ACCESS CODES
A Manager Code should be deleted from the lock if no longer needed, in order
to free the code ID location to be assigned to another Manager User. Manager
Codes that might be needed some time in the future should be de-
activated rather than deleted.
Required User Level: Master
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 201# to delete a Manager Code.
3. Enter the ID location NNN#, where NNN is the specific
Manager ID location, 024 for example.
4. Example of complete entry: 201#024#.
5. Enter another # to indicate the end of programming.
You have now deleted a Manager ID location, and (indirectly) his Access Code,
allowing you to assign that ID location to another Manager or Access User if
you wish.
PROCEDURE 6 - DELETE SERVICE USER ACCESS
A Service User Access Code is automatically deleted from the lock at the end
of its specified length of time. However, use this procedure if you want to delete
the code earlier than the specified expiry time.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 202# to delete Service User Access Code.
3. Enter the ID location NNN#, where NNN is the specific Service User ID
location, 025 for example
4. Example of complete entry: 202#025#.
5. Enter another # to indicate the end of programming.
6. You have now deleted a Service User ID location, and (indirectly) his
access code, allowing you to assign that ID location to another Service
User if you wish.
PROCEDURE 7 - DELETE ALL ACCESS CODES EXCEPT
All codes may be deleted together if you are changing everything because of,
for example, suspected theft of codes. Warning - be sure that you want to do
this, because re-creating codes for all the personnel will be time-consuming at
the pushbuttons.
22
CODES
MASTER, MANAGER AND M-UNIT
Hide quick links:
Advertisement
Table of Contents
