Changing Key-In-Lever/Knob (Kil/Kik) Cylinder - Kaba 5 00 Series Installation Instructions Manual

G. CHANGING KEY-IN-LEVER/KNOB CYLINDER
On key-in-lever/knob models of the E-Plex 5000, the outside lever/knob
comes preassembled with Kaba's key-in-lever/knob cylinder (Kaba 1599).
To use a different key-in-lever/knob cylinder, follow remaining steps in this
section.
G-1 Remove KIL/KIK (key-in-lever/knob) cylinder (a)
from the outside lever/knob (b) by removing the
outside lever/knob sleeve (f). Remove the
cylinder insert (e) (no insert on knobs) and the
cylinder retainer (c) using a small flat blade
screw driver or small needle nose pliers.
TAILPIECE
K1
K2
K3
K4
K5
G-2 Determine the proper tailpiece from the chart above for your KIL/KIK
cylinder.
You must use a Kaba tailpiece. The K 2 tailpiece is preassembled with
the Kaba 1599.
KIL/KIK CYLINDER
Abloy 5277, Abloy 5477, Assa 65691,
Kaba 1539, Kaba Gemini 4730
Assa 65611, Australian: Kaba experT 107K5 &
Boyd KC286, Corbin-Russwin 2000-03, Kaba
1599, Schlage 23-001, Schlage Primus 20-760,
Kaba Peaks 1099
Medeco 20W200H1
Arrow C100, Sargent 10 LINE
Marks
a
d
f
c
e
a
d
f
c
b
b
8