Table of Contents
Advertisement
Display Daylight Savings Time Status
This feature enables managerial personnel to display the Daylight Savings Time status in the lock.
Note: Only the Master User and a Manager User can display Daylight Savings Time status in the lock.
To display Daylight Savings Time status, complete the following steps:
Step
1.
Power lock.
2.
Enter Master User or a
Manager User combination.
3.
Press
then 12.
Enable Palm Communications
This feature provides the function to set up communications between the lock and the Palm organizer.
To enable Palm communications, complete the following steps:
Step
1.
Connect Palm organizer to
lock.
2.
Power lock.
3.
Enter Master User or a
Manager User combination.
4.
Press
then 6.
5.
Perform desired Palm
function.
Detailed Instructions
Power the lock by depressing the outside lever.
Enter the Master User or a Manager User combination. The lock will beep/
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
followed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the combination is not valid, the lock responds with
three beeps/flashes of the red LED.
Before re-lock time expires, press
then the 2 key. The lock responds with two beeps/flashes of the green LED if
lock is on Standard Time and with four beeps/flashes if lock is on Daylight
Savings Time. Subsequently, the lock responds with two simultaneous
beeps/flashes of the green and red LEDs.
Detailed Instructions
Connect the Palm Interface Module to the lock using the interface cable.
Power the lock by depressing the outside lever.
Enter the Master User or a Manager User combination. The lock will beep/
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
followed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the combination is not valid, the lock responds with
three beeps/flashes of the red LED.
Before re-lock time expires, press
lock responds with one beep/flash of the green LED every second until the
Palm interface cable has been inserted into the lock communication
connector.
Turn on the Palm organizer and tap the Connect to PC button at the bottom
of the Main Menu. Tap the appropriate button on the top of the Connect to
Lock menu to perform the desired function.
(Enter key) followed by the 1 key and
(Enter key) followed by the 6 key. The
35
Advertisement
Table of Contents
