Table of Contents
Advertisement
G. CHANGING KEY-IN-LEVER CYLINDER
On key-in-lever models of the E-Plex, the outside lever comes
preassembled with Kaba's key-in-lever cylinder (Kaba 1599). To use a
different key-in-lever cylinder follow remaining steps in this section.
G-1 Remove KIL (key-in-lever) cylinder (a) from
the outside lever (b) by removing the outside
lever sleeve (f). Remove the cylinder insert
(e) and the rubber cylinder retainer (c) using
a small flat blade screw driver or small
needle nose pliers.
G-2 Determine the proper tailpiece (d)
from the chart below for your KIL
cylinder.
You must use a Kaba tailpiece. The K 2 tailpiece is preassembled with the
Kaba 1599.
TAILPIECE
K1
K2
K3
K4
K5
G-3 Assemble the required tailpiece (d) (supplied) with
your KIL cylinder. All tailpieces must be installed
vertically (with key removed from cylinder)
for proper installation.
G-4 Insert the KIL cylinder into the outside lever
(b) and secure it with the cylinder retainer
(c) and the cylinder insert (e) until the KIL
cylinder is snug and unable to move freely.
8
KIL CYLINDER
Abloy 5277, Abloy 5477, Assa 65691,
Kaba 1539, Kaba Gemini 4730
Assa 65611, Australian: Kaba experT 107K5 &
Boyd KC286, Corbin-Russwin 2000-03, Kaba
1599, Schlage 23-001, Schlage Primus 20-760,
Kaba Peaks 1099
Medeco 20W200H1
Arrow C100, Sargent 10 LINE
Marks
a
c
e
d
f
a
c
e
d
b
b
Advertisement
Table of Contents
