Table of Contents
Advertisement
Display Lock Enabled / Disabled Status
Step
1.
Power lock.
2.
Enter Master User or a
Manager User combination.
3.
Press
then 14.
Enable a Keypad User
Note: This operation is used to enable lock access for either Keypad Access Users or Service Users.
Step
1.
Power lock.
2.
Enter Master User or a
Manager User combination.
3.
Press
then 71.
4.
Enter Keypad User ID.
5.
Enter Keypad User ID again.
6.
Repeat Steps 4–5 to enable
more Keypad Users or go to
step 7.
7.
Press
.
24
Detailed Instructions
Power the lock by depressing the outside lever.
Enter the Master User or a Manager User combination. The lock will beep/
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
followed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the combination is not valid, the lock responds with
three beeps/flashes of the red LED.
Before re-lock time expires, press
then the 4 key. The lock responds with two beeps/flashes of the green LED if
the lock is enabled, and with four beeps/flashes of the green LED if the lock
is disabled. Subsequently, the lock responds with two simultaneous
beeps/flashes of the green and red LEDs.
Detailed Instructions
Power the lock by depressing the outside lever.
Enter the Master User or a Manager User combination. The lockwill beep/
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
followed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the combination is not valid, the lock responds with
three beeps/flashes of the red LED.
Before re-lock time expires, press
then the 1 key. The lock responds with two beeps/flashes of the green LED.
Enter the User ID of the Keypad User to be enabled. The lockresponds with
two beeps/flashes of the green LED if the User ID is valid. The lock
responds with two beeps/flashes of the red LED to indicate an error.
Enter the Keypad User ID again for verification. The lock responds with four
beeps/flashes of the green LED. The lock responds with two beeps/flashes
of the red LED if the User ID was unconfirmed, if the User ID was not in use,
or if the User ID was not that of an Access User.
The Keypad User is enabled.
If additional Keypad Users are to be enabled, repeat steps 4-5 until all User
IDs are enabled. If no additional User IDs are to be enabled, go to step 7.
Press
(Enter key) to exit this procedure. The lock responds with two
simultaneous beeps/flashes of the green and red LEDs and exits this
procedure.
(Enter key) followed by the 1 key and
(Enter key) followed by the 7 key and
Advertisement
Table of Contents
