Table of Contents
Advertisement
Step
7.
Attach Palm organizer to PC.
8.
View/Print user table data
stored on Palm organizer.
Load Lock User Table, Holiday & Daylight Savings Time Data Created on PC
This feature provides the function to load Lock User Table, Holiday & Daylights Savings TIme data created with the
PowerLever Door Lock PC software into an activated lock from either an SA Key or a Palm Organizer.
Note: The load lock user table operation requires that the lock be activated.
Lock User Table and/or Holiday & Daylight Savings Time Data Upload Via SA Key
Note: This operation requires an SA key that has been loaded with user table data using the PowerLever Door Lock
PC software. Refer to Appendix B of the PowerLever Door Lock Software Reference Manual for a flowchart of the
Load Lock User Table Data process that combines activity at the lock and the PC.
To upload the data, complete the following steps:
Step
1.
Power lock.
2.
Enter Master User or a
Manager User combination.
3.
Press
then 40.
4.
Insert SA Key into Key reader.
Detailed Instructions
lock serial number and data line number contained in the transaction will dis-
play at the top of the report. All Access Users, Audit Users, Service Users,
and Key Users will appear in the user table list. Master Users and Manager
Users will not display unless the Master User is performing the user informa-
tion retrieval. The report will list all keypad users in numerical order, then any
key users assigned to the lock. For keypad users, the user ID, schedule
assignment and status are displayed. Key users will only display "Key User"
and the status. To navigate the list, move the Scroll Bar on the right side or
tap the Top or Bottom buttons at the bottom of the user table list, if dis-
played. Alternatively, press the upper or lower half of the Palm Scroll Button
(bottom center on Palm organizer) to page up or down. When finished view-
ing the report, tap the Done button at the bottom of the user table list.
Insert the Palm Organizer into the Palm cradle attached to the PC.
Perform a HotSync. Logon to the PC software and click Reports; select List
Lock Data Stored on Palm Organizer. From the "List Lock Data Stored on
Palm Organizer" window, select the desired user table report and click View.
The "User Table Down load Report" window is displayed. View the data, as
needed, and print the data, if required, by clicking the Print button. When
finished click the Close button on the "User Table Download Report" window.
Click the Close button on the "List Lock Data Stored on Palm Organizer"
window.
Detailed Instructions
Power the lock by depressing the outside lever.
Enter the Master User or a Manager User combination. The lock will beep/
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
followed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the combination is not valid, the lock responds with
three beeps/flashes of the red LED.
Before re-lock time expires, press
then the 0 key. The lock responds with one beep/flash of the green LED
every second until the SA key is inserted into the Key reader.
Insert the SA Key into the lock key reader. The lock alternately beeps/flashes
red and green LEDs while user table uploading is in progress.
(Enter key) followed by the 4 key and
33
Advertisement
Table of Contents
