Table of Contents
Advertisement
▪
AUTO CONNECT AFTER POWER UP: Audio
transmission starts automatically after the device
has been powered up.
▪
DECODER PARAMETERS: In the receiver, the data
packets are buffered to compensate for
transmission jitter (= temporal fluctuations in the
reception of packets).
BUFFER MODE: The receive data buffer offers two
▪
modes.
▪
AUTOMATIC: The device monitors the jitter of the
received data packets and automatically adjusts the
size of the receive data buffer to minimise delay while
avoiding packet loss.
▪
FIXED: The buffer size can be set to a fixed value
under BUFFER SIZE. A larger buffer results in a higher
audio delay.
BUFFER SIZE: Set a receive data buffer size
▪
between 20 ms and 2 s.
Line Interface – IP Leased Line Extended (5)
▪
ENCODER PACKET SIZE (PAYLOAD TIME): Some
encoding algorithms do not mandate a specific
size for the IP packets. For the following codecs,
the packet size can be set here in milliseconds.
G.711, G.722, PCM
▪
The device automatically reduces the packet size if
▪
the maximum packet size (MTU) of an Ethernet
frame is exceeded.
▪
LEVEL INFO TRANSMISSION: In COMPATIBILITY
MODE: RAW RTP/MPEG, the audio level at the
encoder input can be transmitted to the remote
device.
▪
INTERVAL: Set the time interval at which the level
information is sent.
▪
UDP PORT: Set the UDP port for sending the level
information.
Advertisement
Table of Contents
