Table of Contents
Advertisement
▪
In the IP LEASED LINE DIAL UP mode, audio is
transmitted directly between two devices.
▪
This mode is compatible with MAGIC ACip3 and
Luci Live.
A connection is established by entering the IP
▪
address of the other device in the dialling window.
The remote device recognises the incoming audio
▪
data stream and adopts the source IP address and
port for sending its own audio stream.
LABEL: Enter any text. The label is displayed in
▪
the main panel of the PC software above the
channel.
AUDIO UDP PORT: Set the UDP port used for
▪
sending and receiving audio data.
AUDIO VLAN: Select which VLAN is used for the
▪
audio transmission. The VLAN must be defined
beforehand on the VLAN configuration page.
Line Interface – IP Leased Line Dial Up (2)
▪
LAN INTERFACE: Define which IP address of the
device is to be used for the audio transmission.
▪
REMOTE GPIO MODE: When connected to a MAGIC
ACip3 or MAGIC AC1 Go, the states of the GPIO
inputs can be transmitted to the remote device.
Specify how the data is transmitted.
OFF: No transmission.
▪
▪
RTP (AVT CODECS ONLY): The states of the inputs
are transmitted in the RTP data stream.
PAD (AVT CODECS ONLY): The states of the inputs
▪
are fed into the coding algorithm as PAD. This is
only supported with MPEG.
Advertisement
Table of Contents
