AVT MAGIC AC1 Go Configuration Manual page 37

REMOTE GPIO MODE: When connected to a MAGIC
▪
AC1 XIP, MAGIC ACip3 or MAGIC AC1 Go, the states
of the GPIO inputs can be transmitted to the
remote device. Specify how the data is transmitted:
▪ OFF: No transmission.
RTP (AVT CODECS ONLY): The states of the inputs are
▪
transmitted in the RTP data stream.
▪ PAD (AVT CODECS ONLY): The states of the inputs are
fed into the coding algorithm as PAD. This is only
supported with MPEG.
DECODER SETTINGS
▪
▪ LABEL: Must be configured on the ENCODER tab.
REMOTE IP ADDRESS: IP address of the remote
▪
device. Incoming data packets are only accepted
from this address.
Line Interface – IP Leased Line Extended (4)
UDP PORT: UDP port used for receiving audio data.
▪
VLAN: Select which VLAN is used for the audio
▪
reception. The VLAN must be defined beforehand
on the VLAN configuration page.
▪ SECURE STREAMING: Receiving two streams with
identical content. The second stream can be
delayed and routed via a different VLAN. Secure
Streaming only works between AVT codecs.
SECURE STREAMING IP ADDRESS: IP address of the
▪
remote device for the second stream. Incoming
data packets are only accepted from this address.
SECURE STREAMING VLAN: VLAN for the reception
▪
of the second stream. The VLAN must be defined
beforehand on the VLAN configuration page. If the
audio transmission is not assigned to a VLAN, select
NO VLAN.
SECURE STREAMING: Enable Secure Streaming for
▪
reception.
AUDIO DELAY SYNC: Enable for reception. See
▪
Encoder settings for further information.