Table of Contents
Advertisement
▪
SECURE STREAMING: Sending two streams with
identical content. The second stream can be
delayed and routed via a different VLAN. Secure
Streaming only works between AVT codecs.
ENABLE: Enable Secure Streaming in the transmit
▪
and receive direction.
▪
REMOTE IP ADDRESS: IP address of the remote
device for the second stream. The encoded data is
sent to this address. Incoming data packets are
only accepted from this address.
AUDIO VLAN: VLAN for the transmission of the
▪
second stream. The VLAN must be defined
beforehand on the VLAN configuration page. If the
audio transmission is not assigned to a VLAN, select
NO VLAN.
LAN INTERFACE: Define which IP address of the
▪
device is to be used for the audio transmission.
SECURE STREAMING DELAY: Time delay for the
▪
second audio streams. This increases the overall
delay of the transmission.
Line Interface – IP Leased Line Standard (3)
▪
DECODER PARAMETERS: In the receiver, the data
packets are buffered to compensate for
transmission jitter (= temporal fluctuations in the
reception of packets).
BUFFER MODE: The receive data buffer offers two
▪
modes.
▪
AUTOMATIC: The device monitors the jitter of the
received data packets and automatically adjusts the
size of the receive data buffer to minimise delay while
avoiding packet loss.
▪
FIXED: The buffer size can be set to a fixed value
under BUFFER SIZE. A larger buffer results in a higher
audio delay.
BUFFER SIZE: Set a receive data buffer size
▪
between 20 ms and 2 s.
▪
ENCODER PACKET SIZE (PAYLOAD TIME): Some
encoding algorithms do not mandate a specific
size for the IP packets. For the following codecs,
the packet size can be set here in milliseconds.
G.711, G.722, PCM
▪
The device automatically reduces the packet size if
▪
the maximum packet size (MTU) of an Ethernet
frame is exceeded.
Advertisement
Table of Contents
